EPOS, ESCON with Pacific-Scientific motor

Topic:

• How has a Pacific-Scientific motor to be connected to a maxon ESCON or EPOS controller?
• What configuration is required to operate the Pacific Scientific motor??
  
  

Solution:

The Pacific Scientific Motor PMB22B-00114-00 is a brushless DC motor with multiple pole pairs (typ. 8 poles = 4 pole pairs). The following points have to be considered for wiring and configuration:

Connections:

• You have to ensure that the wiring of the motor's winding phases, hall sensors signal lines, and hall sensor power is assigned like shown in the following table:
  
  

  Pacific PMB22B assignment	maxon assignment
  Phase U (blue)	Motor winding 1
  Phase V (brown)	Motor winding 2
  Phase W (violet)	Motor winding 3
  *Hall 1 U (violet)	Hall sensor 1
  *Hall 2 V (brown/white)	Hall sensor 2
  *Hall 3 W (orange/white)	Hall sensor 3
  +5V (red)	Vcc Hall 5V (Supply output)
  Supply return (black)	GND

*Hall 1,2,3:
Because of the different polarity definition of the Hall signals of the Pacific-Scientific motor the Hall signals have to be inverted. The inverting can be easily made in the "Startup Wizard" of EPOS/ESCON Studio.

Important: Pin Assignment & cable colours!
Please check the cable colours and naming based on Pacific Scientific's data sheet. maxon cannot take any warranty that the provided information above is still valid. The cable, pin assignment (and technical data as well) might be subject to change by the motor manufacturer! maxon does not take any liability in case of a damage due to a wrong wiring based on the table above.
 

Specific controller parameter settings:

Use the "Startup" wizard of ESCON Studio resp. EPOS Studio to configure the motor and sensor parameters:

• Motor data / "Pole pair number" = typ. 4 (-> check data sheet)
  Remark:
  The value of 4 is typically valid for the PMB22B motor. Other Pacific Scientific motors might have a different pole pair number. Please check the pole pair number by the motor data sheet or ask Dunker about it.
  Number of poles <-> Pole Pair number?
  Please note that the pole pair number has to be configured. There might be the number of poles specified by the data sheet sometimes. The number of poles has to be divided by 2 to get the "Pole pair number" then.
  Hint:
  The "Pole pair number" can be evaluated by ESCON Studio's "Diagnostics" tool.
  
  
• Sensor / "Polarity of Hall sensors": Inverted
  The polarity of the hall sensors has to be configured as "Inverted" by the corresponding dialogue field of the Startup wizard.
  
  
• Sensor / "Encoder resolution": Check data sheet
  Remark:
  There might be encoders with different resolutions (typ. 500 ... 2000 cpt) be combined with Pacific Scientific motors. Please check and configure the resolution actually in use by your motor/encoder combination.
  
  
• Please ensure that all other motor, encoder, and system parameters are configured properly based on the supplier's data sheets.
  
  
  

Final action after completed configuration:

• Execute "Regulation Tuning"!
  
  

Summary

Pacific Scientific brushless DC motors can be controlled by the maxon EPOS or ESCON controllers. It is just required to ...

• ... connect the windings and hall sensors properly.
• ... configure the correct "Pole pair number" (= typ. 4 in case of PMB22B).
• ... configure an inverted "Hall sensor polarity".